How to Set Up a Pi Zero with a 3.5″ touch TFT screen @Raspberry_Pi #PiDay #RaspberryPi

May 19, 2017 Kelly

S l1600

Handy write-up from Mark William Davies.

The first step is to attach the screen to the device. To connect it to the Pi Zero you need to solder on the 2 x 20 GPIO header pins (not covered in here, but you can find it on the net elsewhere). The screen plugs onto the GPIO pins so that the screen covers the Pi (the cluster of 4 connector sockets go onto the pins that are next to the SD card socket).

Read more.